 Available
in steam from 15 PSIG.
up to 300 PSIG.
Available in Hot Water from 30 PSIG.
up to 160 PSIG.
@ 250°F
Capacities from 100 to 225 H.P. | 3347 to 7532 MBTU/HR.
UL
Approved Forced Draft Burners
- Efficient
3-Pass Wet Back Design
- Front & Rear
Smoke Boxes are Bolt-On Type For Easy Removal
- ASME Code
Constructed & Stamped For Pressures to 300 PSI
- Registered
With The National Board of Boiler Inspectors
- Low Furnace
Heat Release
- Large Furnace
Volume For Ultimate Combustion Efficiency
- Steel Skids
and Lifting Eyes
- U.L. Listed
Controls & Trim
- Competitively
Priced, Easily Maintained, Designed For Efficiency
- Flame Observation
Ports - Front & Rear
- Factory Insulated
- Baked-on
- Easy Access
to Fireside Surfaces
- Ample Water
Side Cleanout Openings
- Fully Automatic
Operation
- U.L. Listed,
Forced Draft Burners
- Fuel Flexibility
- Gas, Oil and Combination Gas/Oil
- Also available
in 200 Series & 300 Series Dryback Boilers
STANDARD
FEATURES
All units are factory
packaged with operating controls, relief valves, burner and fuel train. Installation
is made simple in that only service connections are needed to place in operation.
Flexible burner systems are available for firing natural gas, LP gas, #2-6
oil or combinations. High density mineral wool insulation assures lower radiant
heat loss. In addition to meeting the requirements of UL, burner systems
are optionally available to meet the requirements of FM, IRI, CSD-1 and others.
Steam
Trim
Steam pressure gauge with syphon and testcock; combination low water
cutoff and pump control (or feeder); water column gauge glass set
and drain valve; probe type Aux. L.W.C.O.; ASME safety relief valve(s);
operating and high limit.
Water
Trim
Combination pressure and temperature gauge, low water
cutoff control, ASME relief valve(s), operating and high limit controls.
|
